'
HUZ4201XR is designed as HGU (Home Gateway Unit) in different FTTH solutions. The carrier-class FTTH application provides data service access.
HUZ4201XR is designed as HGU (Home Gateway Unit) in different FTTH solutions. The carrier-class FTTH application provides data service access. HUZ4201XR is based on mature and stable,cost-effective XPON technology. It could switch automatically into EPON mode or GPON GPON mode when access to the EPON OLT and GPON OLT.
HUZ4201XR adopts high reliability, easy management, configuration flexibility and good quality of service guarantees to meet the technical performance of EPON Standard of China Telecom CTC3.0 and GPON Standard of ITU-TG.984.X
●Support EPON/GPON mode and switch mode automatically.
●Support Route mode for PPPoE/DHCP/Static IP and Bridge mode.
●Support IPv4 and IPv6 Dual mode.
●Support 2.4G&5.8G WIFI and Multiple SSID.
●Support IEEE 802.ax.
●Support SIP Protocol for VoIP Service.
●Support LAN IP and DHCP Server configura- tion.
●Support Port Mapping and Loop-Detect.
●Support Firewall function and ACL function.
●Support IGMP Snooping/Proxy multicast feature.
●Support TR069 remote configuration and maintenance.
●Specialized design for system breakdown prevention to maintain stable system.
|
Technical item |
Details |
|
PON Interface |
1 GPON BoB（ Bosa on Board）Receiving sensitivity: ≤-27dBmTransmitting optical power: 0~+5dBmTransmission distance: 20KM |
|
Wavelength |
TX: 1310nm, RX: 1490nm |
|
Optical Interface |
SC/APC Connector |
|
Chip Spec |
ZX279128S DDR3 4Gbit |
|
Flash |
2Gbit SPI NAND Flash |
|
LAN Interface |
4 x 10/100/1000Mbps auto adaptive Ethernet interfaces. Full/Half, RJ45 connector |
|
Wireless |
Compliant with IEEE802.11b/g/n, a, ac, ax2.4G Operating frequency:2.400-2.4835GHz5.8G Operating frequency:5.150-5.825GHz2.4G 2*2 MIMO, rate up to 574Mbps5.8G 2*2 MIMO, rate up to 2402Mbps4 external antennas 5dBiSupport Multiple SSID |
|
VoIP Interface |
FXS, RJ11 connectorSupport: G.711/G.723/G.726/G.729 codecSupport: T.30/T.38/G.711 Fax mode, DTMF RelayLine testing according to GR-909 |
|
CATV Interface |
RF, WDM, optical power: +2~-15dBmOptical reflection loss≥45dBOptical receiving wavelength: 1550±10nmRF frequency range: 47~1000MHz, RF output impedance: 75ΩRF output level: 78dBuVAGC range: -13~+1dBmMER≥32dB@-15dBm |
|
USB |
USB3.0 |
|
LED |
11 LED, For Status of WPS, 5G, WLAN, FXS, LAN1, LAN2, LAN3, LAN4, PON, POWER, Worn(CATV), Normal(CATV) |
|
Push-Button |
3, For Function of Factory Reset, WPS, WiFi |
|
Operating Condition |
Temperature: 0℃~+50℃Humidity: 10%~90% (non-condensing) |
|
Storing Condition |
Temperature: -30℃~+60℃Humidity: 10%~90% (non-condensing) |
|
Power Supply |
DC 12V/1.5A |
|
Power |
≤6W |
|
Dimension |
293mm×144mm×54mm（ L×W×H） |
|
Net Weight |
350g |
| Pilot Lamp |
Status |
Description |
|
PWR |
ON |
The device is powered up. |
|
OFF |
The device is powered down. | |
|
LOS |
BLINK |
The device doses not receive optical signals or with low signals. |
|
OFF |
The device has received optical signal. | |
|
PON |
ON |
The device has registered to the PON system. |
|
BLINK |
The device is registering the PON system. | |
|
OFF |
The device registration is incorrect. | |
|
Worn |
ON |
Input optical power is higher than 3dbm or lower than -15dbm |
|
OFF |
Input optical power is between -15dbm and 3dbm | |
| Normal |
ON |
Input optical power is between -15dbm and 3dbm |
|
OFF |
Input optical power is higher than 3dbm or lower than -15dbm | |
|
2.4G |
ON |
2.4G WIFI interface up. |
|
BLINK |
2.4G WIFI is sending or/and receiving data(ACT). | |
|
OFF |
2.4G WIFI interface down | |
|
5.8G |
ON |
5G WIFI interface up |
|
BLINK |
5G WIFI is sending or/and receiving data (ACT). | |
|
OFF |
5G WIFI interface down | |
|
WPS |
ON |
The WIFI interface is securely establishing a connection |
|
OFF |
The WIFI interface does not establish a secure connection. |
. Typical Solution: FTTH(Fiber To The Home).
. Typical Business: INTERNET, IPTV, WIFI, VOIP, etc.
Figure: HUZ4201XR Application Diagram
Products categories
Write your message here and send it to us