1.Overview
HUR3009XR is designed as HGU (Home Gateway Unit) in deferent FTTH solutions by HDV, The carrier-class FTTH application provides data service access.
HUR3009XR is based on mature and stable, cost-effective XPON technology. It can switch automatically with EPON and GPON when it access to the EPON OLT or GPON OLT.
HUR3009XR is based on mature and stable, cost-effective XPON technology. It can switch automatically with EPON and GPON when it access to the EPON OLT or GPON OLT.
HUR3009XR adopts high reliability, easy management, configuration flexibility and good quality of service (QoS) guarantees to meet thetechnical
performance of the module of China Telecom EPON CTC3.0 and GPON Standard of ITU-TG.984.X
HUR3009XR series is designed by Realtek chipset 9603C.
2.Ordering information
|
Product Name |
Product Model |
Descriptions |
|
SFF Type XPON ONU |
1G1F+WIFI+CATV |
1x10/100/1000Mbps Ethernet, 1 x 10/100Mbps Ethernet , 1 SC/APC Connector, 2.4GHz WIFI,1 RF Output Interface ,Plastic Casing, External power supply adapter |
Hardware Specification
| Technical item | Details |
| PON Interface | 1 G/EPON port(EPON PX20+ and GPON Class B+) |
| Receiving sensitivity: ≤-27dBm | |
| Transmitting optical power: 0~+4dBm | |
| Transmission distance: 20KM | |
| Wavelength | TX: 1310nm, RX: 1490nm |
| Optical Interface | SC/APC Connector |
| LAN Interface | 1 x 10/100/1000Mbps and 1 x 10/100Mbps auto adaptive Ethernet interfaces. Full/Half, RJ45 connector |
| CATV Interface | RF, WDM ,optical power : +2~-18dBm |
| Optical reflection loss: ≥45dB | |
| Optical receiving wavelength: 1550±10nm | |
| RF frequency range: 47~1000MHz, RF output impedance: 75Ω | |
| RF output level: 78dBuV | |
| AGC range: 0~-15dBm | |
| MER: ≥32dB@-15dBm |
| Wireless | Compliant with IEEE802.11b/g/n, |
| Operating frequency: 2.400-2.4835GHz | |
| support MIMO, rate up to 300Mbps, | |
| 2T2R,2 external antenna 5dBi, | |
| Support: Multiple SSID | |
| Channel: Auto | |
| Modulation type: DSSS, CCK and OFDM | |
| Encoding scheme: BPSK, QPSK, 16QAM and 64QAM |
| LED | 9 LED, For Status of WIFI,WPS,PWR,LOS,PON,LAN1~LAN2,Worn, Normal(CATV) |
| Push-Button | 3,For Function of Reset, WLAN, WPS |
| Operating Condition | Temperature: 0℃~+50℃ |
| Humidity: 10%~90%(non-condensing) | |
| Storing Condition | Temperature: -30℃~+60℃ |
| Humidity: 10%~90%(non-condensing) | |
| Power Supply | DC 12V/1A |
| Power Consumption | ≤6W |
| Dimension | 155mm×92mm×34mm(L×W×H) |
| Net Weight | 0.24Kg |
Panel lights Introduction
|
Pilot Lamp |
Status |
Description |
|
WIFI |
On |
The WIFI interface is up. |
|
Blink |
The WIFI interface is sending or/and receiving data (ACT). | |
|
Off |
The WIFI interface is down. | |
|
WPS |
Blink |
The WIFI interface is securely establishing a connection. |
|
Off |
The WIFI interface does not establish a secure connection. | |
|
PWR |
On |
The device is powered up. |
|
Off |
The device is powered down. |
|
LOS |
Blink |
The device doses not receive optical signals. |
|
Off |
The device has received optical signal. | |
|
PON |
On |
The device has registered to the PON system. |
|
Blink |
The device is registering the PON system. | |
|
Off |
The device registration is incorrect. | |
|
LAN1~LAN2 |
On |
Port (LANx) is connected properly (LINK). |
|
Blink |
Port (LANx) is sending or/and receiving data (ACT). | |
|
Off |
Port (LANx) connection exception or not connected. |
|
Worn (CATV) |
On |
Input optical power is higher than 3dbm or lower than -13dbm |
|
Off |
Input optical power is between -13dbm and 3dbm | |
|
Normal (CATV) |
On |
Input optical power is between -13dbm and 3dbm |
|
Off |
Input optical power is higher than 3dbm or lower than -13dbm |
Typical Solution:FTTO(Office), FTTB(Building),FTTH(Home)
Typical Business:INTERNET,IPTV,IP Camera ,WIFI ,CATV etc
Typical Business:INTERNET,IPTV,IP Camera ,WIFI ,CATV etc
Figure: HUR3009XR Application Diagram
Products categories
Write your message here and send it to us