Renewable Design for Copper Sfp Module - 1.25G 20KM 1310nm Dual Fiber Single mode SFP module – HDV Detail:
Applications
Switch
Video monitor system Telecommunication system
Absolute Maximum Ratings
| Parameter | Symbol | Min | Max | Unit | |
| Storage Temperature | TS | -40 | +85 | ℃ | |
| Operating Temperature | TOP | Commercial level | -20 | +70 | ℃ |
| industrial level | -40 | 85 | |||
| Supply Voltage | VCC | -0.5 | +4.5 | V | |
| Voltage on Any Pin | VIN | 0 | VCC | V | |
| Soldering Temperature ,Time | - | 260℃, 10 S | ℃,S | ||
Recommended Operating Conditions
| Parameter | Symbol | Min. | Typ | Max. | Unit | |
| Ambient Temperature | TAMB | Commercial level | 0 | - | 70 | ℃ |
| industrial level | -40 | 85 | ||||
| Power Supply Voltage | V CC-VEE | 3 | 3.3 | 3.6 | V | |
Operating Conditions
1 Transmitter（T=25℃, Vcc=3~3.6V (+3.3V)） 1.25G
| Parameter | Symbol | Min. | Typ | Max. | Unit | |||
| Center Wavelength | lc | FP OR DFB | 1520 | 1550 | 1580 | nm | ||
| 1280 | 1310 | 1340 | ||||||
| CWDM | l-6 | l(note1) | l+6 | |||||
| Spectral width | △l | FP@RMS | - | 1 | 2 | nm | ||
| DFB@-20dBFWHM | - | - | 1 | |||||
| Side Mode Suppression Ratio | SMSR (DFB only) | 30 | dB | |||||
| Output Power | 0~20km | 1310 FP | Po | -9 | - | -3 | dBm | |
| 20km | 1550 DFB | -9 | - | -0 | ||||
| CWDM |
-9 |
- |
-0 |
||||
| 40km | 1550 DFB |
-5 |
0 |
||||
| CWDM |
-5 |
0 |
|||||
| 80km | 1550 DFB |
-3 |
2 | ||||
| CWDM |
-3 |
2 | |||||
| Extinction Ratio | ER | 1.25G | 9 | - |
dB |
||
| Supply Current | ICCT | - |
150 |
mA |
|||
| Input Differential Impedance | Rin | 100 |
Ω |
||||
| Data Input Swing Differential | Vin |
300 |
1200 |
mV |
|||
| Optical Modulation Amplitude | OMA |
174 |
μW |
||||
| Transmit Disable Voltage | VD |
2.0 |
Vcc |
V |
|||
| Transmit Enable Voltage | VEN | 0 |
0.8 |
V |
|||
| Transmit Disable Assert Time |
10 |
us |
|||||
| Optical Rise/Fall Time | Tr/ Tf (20-80%) | 150 |
260 |
ps |
|||
| Deterministic Jitter Contribution | TX ΔDJ |
51.7 |
ps |
||||
| Total Jitter Contribution | TX ΔTJ |
90 |
ps |
||||
| Output Optical Eye | IUT-T G.957 Compliant | ||||||
Note1: l:1270,1290,1310,1330,1350,1370,1390,1410,1430,1450,1470,1490,1510,1530,1550,1570,1590,1610.nm
2 Receiver （T=25℃, Vcc=3~3.6V (+3.3V) 1.25G
| Parameter | Symbol | Min. | Typ | Max. | Unit | |||
| Wavelength Range | lc | 1100 | 1610 | nm | ||||
| Sensitivity | 0~20km | 1.25G | Pin | PMIN | - | -24 | -23 | dBm |
| 40km | Pin | - | -25 | -24 | ||||
| 80km | Pin | - | -27 | -26 | ||||
| MAX. Input Power (Saturation) | PMAX | -3 | - | - | ||||
| Signal Detect Assert | PA | - | - | -24 | ||||
| Signal Detect De-assert | PD | -34 | - | - | ||||
| Signal Detect Hysteresis | PHYS | 1 | - | 4 | ||||
| Supply Current | ICCR | - | - | 150 | mA | |||
| Data Output Swing Differential | Vout | 400 | - | 1000 | mV | |||
| Signal Detect Voltage – High | VSDHC | 2.0 | - | VCC | V | |||
| Signal Detect Voltage – Low | VSDL | 0 | - | 0.8 | ||||
Notes:
switch from a high state to a low state.
1)Value of output power and sensitivity can be customized according to the demand
Ordering Information
Example
DSFP 49 24-C 1 2 LC - 80
| Sign | Mean | Description | |||||
| DSFP |
Module type |
DSFP= Dual fibers SFP | SFP=Single fiber SFP | ||||
| 49 |
Center wave |
30=1310tx/NO rx | 50=1550tx/NO RX | CWDM Like 49=1490 CWDM TX 1100~1610 RX | |||
| 24 | date Rate | 03=155M | 12=622M | 24=1.25G | 48=2.5G | 60=3.125G | |
| C | Laser type | F=FP | D=DFB | C=CWDM | V=VCSEL | ||
| 1 |
Operating T |
1=-20~+70℃ | 2=-40~+85℃ | ||||
| 1 | DDMI | 1=NO DDM | 2=DDMI | ||||
| LC | Connector | SC=SC | LC=LC | ||||
| 80 | Distance | 022=220M | 055=550M | 5=5KM | 10=10KM | ||
| 20=20KM | 40=40KM | 80=80KM | 100=100KM | ||||
Example
DSFP 3X 24-0 12 LC - 80
| Sign | Mean | Description | |||||
| DSFP |
Module type |
DSFP= Dual fibers SFP | SFP=Single fiber SFP | ||||
| 3X |
Center wave |
88=850NM T&R | 3x=1310 tx/1100~1610 RX | CWDM Like 49=1490 CWDM TX 1100~1610 RX | |||
| 24 | date Rate | 03=155M | 12=622M | 24=1.25G |
48=2.5G |
60=3.125G | |
| 0 | Laser type | 0=no LD | |||||
| 1 |
Operating T |
1=-20~+70℃ | 2=-40~+85℃ | ||||
| 2 | DDMI | 1=NO DDM | 2=DDMI | ||||
| LC | Connector | SC=SC | LC=LC | ||||
| 20 | Distance | 022=220M | 055=550M |
5=5KM |
10=10KM | ||
| 20=20KM | 40=40KM |
80=80KM |
100=100KM | ||||
Typical products
| Part No. | Wavelength | Con- nector | Temp. | TXPower (dBm) | RX Sens(Max.) (dBm) | DD MI | Distance |
| DSFP3X24-F11LC-20 | T 1310FP/rx 1100~1610 |
LC |
-20 to 70 | -9 to-0 | -23 | F | 20km |
| DSFP5X24-D12LC-40 | T 1550DFP /R 1100~1610 |
LC |
-20 to 70 | -5~0 | -24 | T | 40KM |
| DSFP6124-C12LC-80 | T 1610 CWDM/ R1100~1610 |
LC |
-20 to 70 | -3 to 2 | -26 | T | 80km |
Designing notice
DSFP Pin description
|
Pin |
Descriptions | Pin | Descriptions |
|
1 |
VEET | Transmitter Ground (Common with Receiver Ground) | 1 |
|
2 |
TFAULT | Transmitter Fault. | 2 |
|
3 |
TDIS | Transmitter Disable. Laser output disabled on high or open. | 3 |
|
4 |
MOD_DEF(2) | Module Definition 2. Data line for Serial ID. | 4 |
|
5 |
MOD_DEF(1) | Module Definition 1. Clock line for Serial ID. | 4 |
|
6 |
MOD_DEF(0) | Module Definition 0. Grounded within the module. | 4 |
|
7 |
Rate Select | No connection required | |
|
8 |
LOS | Loss of Signal indication. Logic 0 indicates normal operation. | 5 |
|
9 |
VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
|
10 |
VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
|
11 |
VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
|
12 |
RD- | Receiver Inverted DATA out. AC Coupled | |
|
13 |
RD+ | Receiver Non-inverted DATA out. AC Coupled | |
|
14 |
VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
|
15 |
VCCR | Receiver Power Supply | |
|
16 |
VCCT | Transmitter Power Supply | |
|
17 |
VEET | Transmitter Ground (Common with Receiver Ground) | 1 |
|
18 |
TD+ | Transmitter Non-Inverted DATA in. AC Coupled. | |
|
19 |
TD- | Transmitter Inverted DATA in. AC Coupled. | |
|
20 |
VEET | Transmitter Ground (Common with Receiver Ground) | 1 |
Small Form-factor Pluggable (SFP) Transceiver MultiSource Agreement (MSA)
SFP Host Board Mechanical Layout
Product detail pictures:
Related Product Guide:
SFP-DD MSA targets 50-Gbps, 100-Gbps optical transceivers | Module Sfp
Dell EMC Networking S4048 S-Series 10GbE Switch Review | StorageReview.com | Single Fiber Sfp Module
To get the stage of realizing dreams of our employees! To build a happier, more united and much more skilled crew! To reach a mutual benefit of our prospects, suppliers, the society and ourselves for Renewable Design for Copper Sfp Module - 1.25G 20KM 1310nm Dual Fiber Single mode SFP module – HDV , The product will supply to all over the world, such as: Macedonia, Atlanta, Karachi, We have now a good reputation for stable quality goods, well received by customers at home and abroad. Our company would be guided by the idea of "Standing in Domestic Markets, Walking into International Markets". We sincerely hope that we could do business with car manufacturers, auto part buyers and the majority of colleagues both at home and abroad. We expect sincere cooperation and common development!
By Matthew from Netherlands - 2015.11.22 12:28
The sales person is professional and responsible, warm and polite, we had a pleasant conversation and no language barriers on communication.
By Griselda from Morocco - 2016.04.18 16:45
Products categories
Write your message here and send it to us