● HTR5033X is designed as SFU/HGU in differ-ent FTTH solutions, The carrier-class FTTH application provides data service access.
● HTR5033X is based on mature and stable, cost-effective XPON technology. It can switch automatically with EPON and GPON mode
when access to the EPON OLT or GPON OLT.
● HTR5033X adopts high reliability, easy man- agement, configuration flexibility and good quality of service (QoS) guarantees to meet the technical performance of the module of China Telecom EPON CTC3.0 and GPON Standard of ITU-TG.984.X
● Support SFU/HGU type and switch mode from ONU Webpage
● Support EPON/GPON mode and switch mode automatically
● Support Route PPPoE/IPoE/Static IP and Bridge mode
● Support IPv4/IPv6 Dual mode
● Support Firewall function and IGMP multicast feature
● Support LAN IP and DHCP Server configuration
● Support Port Forwarding and Loop-Detect
● Support TR069 Remote Configuration and mainte- nance
● Specialized design for system breakdown preven- tion to maintain stable system
HARDWARE SPECIFICATION
| Technical item | Details |
| PON Interface | 1 GPON BOB （ Bosa on Board） Receiving sensitivity: ≤-27dBm Transmitting optical power: 0~+5dBm Transmission distance: 20KM |
| Wavelength | TX: 1310nm, RX: 1490nm |
| Optical Interface | SC/UPC Connector(Regular) SC/APC(Customize) |
| Chip Spec | RTL9601D,DDR2 32MB |
| Flash | SPI Nor Flash 16MB |
| LAN Interface | 1x 10/100/1000Mbps auto adaptive Ethernet interface. RJ45 connector |
| LED | 4 LED, For Status of PWR、 LOS、 PON、 LINK/ACT |
| Push-Button | 2,For Function of Power Switch, Factory Reset |
| Operating Condition | Temperature: 0 ℃~+50 ℃ |
| Humidity: 10% ～90%（ non-condensing） | |
| Storing Condition | Temperature: -30℃~+60 ℃ |
| Humidity: 10%~90%（ non-condensing | |
| Power Supply | DC 12V/0.5A |
| Power Consumption | <3W |
| Dimension | 120mmx78mmx30mm(L×W×H) |
PANEL LIGHTS INTRODUCTION
|
Pilot Lamp |
Status |
Description |
|
PWR |
On |
The device is powered up |
|
Off |
The device is powered down |
|
|
PON |
On |
The device has registered to the PON system. |
|
Blink |
The device is registering the PON system. |
|
|
Off |
The device registration is incorrect. |
|
|
LOS |
Blink |
The device doses not receive optical signals or with low signals |
|
Off |
The device has received optical signal. |
|
|
LINK/ACT |
On |
Port is connected properly (LINK) |
|
Blink |
Port is sending or/and receiving data (ACT). |
|
|
Off |
Port connection exception or not connected. |
APPLICATION
● Typical Solution：FTTO(Office)、 FTTB(Building)、FTTH(Home)
● Typical Business：INTERNET、IPTV etc
Products categories
Write your message here and send it to us